Ametek 241CE II User Manual

6-46 | Model 241CE II Hydrocarbon Dewpoint Analyzer
Extended Status Code (XSCode), Alarm Conditions, and
Corrective Action
This section lists the primary code, error code, alarm type, condition/de-
scription, and suggested corrective actions. If no alarms are present, the
primary XSCode ‘0’ is returned by the system.
The ‘w’ or ‘f’ preceding a message indicates a ‘w’arning or ‘f’ault
alarm condition.
Primary Error Alarm
Code Code Type Condition / Description / Suggested Corrective Action
0 — — No Warnings or Faults
If the primary code returned is ‘0’, no Warnings or Faults exist.
This is not an alarm.
Corrective Action:
No action is required.
1 1 Warning w EEP Warn [End-Of-EEPROM-Life]
The number of times that conguration data has been rewritten
to the EEPROM has exceeded the safe number.
Corrective Action:
• Replace the EEPROM as soon as possible. Record all
conguration values before removing the EEPROM. Upon
receiving a new EEPROM from AMETEK, re-enter the
parameters to ensure your analyzer will operate the same
as it did prior to replacing the EEPROM.
Alternatively, you can send the conguration values and
P.O. number for the EEPROM to AMETEK at the same
time. At the factory, AMETEK will program the customer-
specic parameters in the EEPROM. In this case, you will
only have to install the EEPROM; the parameters will take
e󰀨ect immediately upon power-up.
• After installing the new EEPROM, enter the conguration
values you recorded before removing it (if the EEPROM
was not pre-congured by AMETEK).

NOTE

Ametek 241CE II Specifications

General

Brand	Ametek
Model	241CE II
Category	Measuring Instruments
Language	English