System Overview | 2-15
Communications Interface
There is one communications interface on the WDG-V.
RS485 MODBUS RTU Configuration:
Two Wire 57.6 Kbaud No Parity 1 Stop Bit
The WDG-V is configured, calibrated and monitored via the MODBUS
RTU interface. AMETEK provides two options for communicating with
the WDG-V:
• AMEVision Display User Interface (Reference separate manual)
• WDG-V Configurator Software via PC (Provided with each unit)
Since the interface is industry standard MODBUS, custom user software
can also be written. For this purpose, refer to Chapter 11 for the MODBUS
MAP or consult the factory for the MODBUS register definitions.
To Next Page
Loading...
Need help?
General
