3-2 | Thermox WDG-V / VC / VCM with Blow Back
Analyzer Location
Observe the following guidelines when selecting an analyzer installation
location:
1. Select a readily accessible position for the analyzer to allow for routine
maintenance. Comfort levels for maintenance personnel should be
considered in placement of the sensor and AMEVision Display User
Interface.
2. The installation location should be free from excessive vibration and
the ambient temperature is required to be within the limits listed in
the specifications. If the ambient temperature is outside the specified
limits or the vibration is excessive, please contact AMETEK/Thermox
Sales or Service Department at (412) 828-9040. We have special options
to address ambient temperatures outside the listed specifications.
This chapter shows you how to install your WDG-V sensor components
and AMEVision Display User Interface, and includes the following sec-
tions:
• Inspection of Shipping Contents
• Mechanical Installation
• Wiring
If you have an oxygen-only analyzer without the combustibles option, the
combustibles and methane options described in this chapter do not apply.
These combustibles and methane sections are clearly identified. Likewise,
if you have the combustibles option, but not the methane option, you can
skip all sections pertaining to methane.
Inspect Shipping Contents
Remove any packing material from the WDG-V sensor. Check for damage.
If any is found, notify the shipper.
To Next Page
Loading...
Need help?
General
