1-14
S-4000
Revised 01/2005
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
OPERATOR INSTRUCTIONS
Stopping the Machine
To perform an emergency stop during a sewing cycle:
Pressing the red emergency stop push-button, located on top of the sewing head,
immediately stops the sewing cycle. The red lamp flashes and the machine will not
start.
Press the red main machine power off push button.
To resume operation:
To release the emergency stop, press the red emergency stop push-button, the red
lamp stops flashing and the machine is in the ready to sew stage. The machine may
stop anywhere in the cycle. If the machine stops with the needle in the fabric, the fabric
cannot be removed, manually rotate the handwheel to raise the needle out of the
fabric. Press the clamp up/down push-button to raise the clamps.
Press the black power on push button, the machine is ready to sew.
Emergency stop Red lamp Green lamp
Main
power
on/off
Handwheel
Clamp Up/Down
push-button
To Next Page
Loading...
