S-4000
1-27
Revised 01/2005
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
LCD DISPLAY PROGRAMMING
COUNTERS
SOFT ST (Soft Start) - In parameter Soft St set needed number of stitches for slow start.
Range: 1 to 3 stitches
Step increments: 1 stitch
Default Setting: 1 stitch
TOGGLE SWITCHES - Set by the software.
SOFT STRT (Soft Start) - It switches on or off with set values in “Soft Strt”.
Default Setting: Off
STRTmode (Start Mode) - Switches the Start mode from 1 step to 2 step.
1 Step: First position: clamp feet close at the same time as start of the sewing cycle.
2 Step: First position the clamp feet close, the second position starts the sewing cycle.
Default Setting: 2 Step
STRT. SW. (Start Sew) - Switches foot pedal control dependent on starts the sewing cycle. In conjunction
with the wait time, determines the amount of wait time between the sewing cycles, for the clamps to lower,
when the foot treadle is pressed. In set “Continue”.
Continue: Stepping on the foot treadle, dependent on wait time, will automatically sew the next buttonhole.
Neutral: Stepping on the foot treadle, the buttonhole is sewn, to start the next buttonhole, release the treadle
and press the treadle again.
Default Setting: Neutral
To Next Page
Loading...
