3.6.3. Hydraulic tank oil level check
Check and maintain oil level. Indicator lamp will signal any •
oil loss below “STOP” (engine stops).
Note:
Engine can be started only after oil is lled up.
! NOTE !
If the oil level falls below the lower edge of the
”MIN” oil-level indicator, the engine will automati-
cally stop and signal lamp 27 will light up.
NOTE
In case of more extensive losses nd the location of hydraulic
system leaks and repair the cause.
By stopping the engine in case of oil leakage, the hydraulic sys-
tem of the machine is protected and operation is environment-
friendly, since in case of hydraulic hose damage not all the con-
tent of the hydraulic tank but only limited amount would leak
out. The engine can only be started after relling oil.
3.6.4. Crankcase breather tube
Check crankcase bleeding pipe to avoid its contamination •
with deposits.