Ammann ASC 110 - Machine Control and Use; Starting the Engine

71ASC 110
396056
3
1
2
5
6
396057
2
N
396120A
F8 - 1A
F7 - 20A
F6 - 15A
F5 - 5A
F4 - 1A
F3 - 7,5A
F2 - 10A
F1 - 20A
IDLE
IDLE
277009
1
2
2.7. Machine control and use
2.7.1. Starting the engine
Before starting the engine, please con-
rm nobody gets endangered when en-
gine is started!
How to start:
Pump fuel via feed hand pump on the engine (upon long
•
term shutdown of the Machine).
Check ”TOTAL STOP” 6 is o, and brake 5 is on, and actuator
•
2 in neutral.
Turn on IDLE 1 engine idling switch.
•
Note
Use switch 2 for stepping of idling at IDLE switched on to se-
lect idle rpm from 800 ÷ 1000 min
-1
with engine heated to 30 °C
(86 °F). Newly selected rpm will be stored in engine ECM memo-
ry and remain set for next engine starting.
It is recommended not to alter RPM of
850 min
-1
set by Manufacturer since
Roller’s parameters have been adjusted
to this RPM.
Cut in battery disconnector. •