88 ASC 110
2.8. How to transport the Machine
The machine can move on its own between working sites. •
When moving on the working site, ob-
serve the safety measures applicable to
the working site.
When driving for long distances, 1-hour
cooling breaks after 3 hours of driving
should be taken. Failing that, you are ex-
posed to the risk of damage to the ma-
chine for which the manufacturer is not
responsible.
Make sure the transport carrier is braked
and mechanically secured against unde-
sired motion with scotch blocks 3 when
loading or unloading.
When moving onto the transport carrier
you must switch ON the function of Drum
Slip Limitation. At the same time we rec-
ommend to put rubber bands or wooden
planks, etc. underneath the drum.
The machine on the vehicle must be
properly tied and mechanically secured
against longitudinal and lateral displa-
cement as well as against tipping 1. The
drums must be secured using scotch
blocks 2. The maximum permitted force
for fastening the machine to a vehicle
using rear slings is 5 t.
When on the road, the machine should be transported on •
a vehicle.
When transporting the machine on a ve-
hicle, observe the regulations in force in
the given territory.
To Next Page
Loading...
