Ammann ASC 110 - Banned Operations

27ASC 110
OPERATION MANUAL
2.1.4. Banned Operations
Banned are the following
Operate the machine in the explosive environment and un-
•
derground.
To use the Machine following ingestion of alcoholic bewe-
•
rages or dopes.
To use the Machine if its operation might put its technical
•
condition, safety (life, health) of persons, facilities or objects,
or road trac and its continuity, at risk.
Put into operation and use the Machine when other persons
•
are within its hazardous reach - exception is training a driver
by lector.
Put into operation and use the Machine when some of its
•
safeguarding device (emergency brake, driving brake, horn,
etc.) has been dismantled or damaged.
To roll and compact at such slopes where Machine stability
•
would be disrupted (turning over). Machine’s static stability
stated will lower by drive’s dynamic eects.
To roll and compact at such angles of slopes where hazard
•
of soil breaking o (dropping) under the Machine exists, or
loss of adhesion followed by uncontrolled slip might occur.
To control the Machine in some other way than stated in Dri-
•
ving Manual.
To roll and compact per bearing capacity of subsoil at such
•
a distance from the edge of slope or trenches, where hazard
of landslide or shoulder breaking o (dropping) together
with the Machine would occur
To roll and compact with vibration at such a distance from •
the walls, cuts, slopes, where their slip (slide) would happen
and the Machine covered in.
To compact with vibration at such a distance from buildings •
or facilities and equipment within which the risk of them be-
ing damaged due to vibration transfer impact, would occur.
To operate the Machine unless driver control stand xed
•
properly.
To operate the Machine when engine bay cover is open.
•
To move and transport persons on the Machine.
•
To operate the Machine when within hazardous reach the-
•
reof are other machines or transportation means aside from
those that operate in mutual concert with the Machine.
To operate the Machine at places impossible to see from dri-
•
ver’s stand, and where hazard to people or property could
occur unless work safety has been secured through some
other way like for instance via signalling by duly instructed
person.
To work with the Machine at a protected zone of electric li- •
nes or substations.
To cross electric cables if these are not properly protectedli
•
against mechanical damage.
To operate the Machine under lowered visibility or at night,
•
unless Machine’s working area and workplace are illumina-
ted suciently.
To leave driver’s cockpit of the Machine when the Machine
•
is running.
Boarding or or getting o while on the run, jumping o the
•
Machine.
Sit or stand on the outside parts of the Machine when dri-
•
ving, or stand on the steps.
Leave unsecured Machine - move away from the Machine
•
without having prevented its misuse.
Disable safeguarding, protective or locking systems or alter
•
their parameters.
Use the Machine with oil, fuel, cooling liquid or other llings
•
leaking.
Start the engine through some other way than given in the
•
Driving Manual.
Locate some other items (tools, accessories) aside from per-
•
sonal needs at driver’s stand.
Lay away material or other objects on the Machine.
•
Remove dirt while the Machine is running.
•
Perform maintenance, cleaning or repairs with the Machine
•
not secured against spontaneous move or accidental start,
and when contact of a person with moving parts of the Ma-
chine is not excluded.
Contact of moving parts of the Machine with human body
•
or objects and tools held in hands.
Smoke or handle open re when checking or pumping fuels,
•
relling oils, lubricating the Machine, or inspecting the accu-
mulator or making up the accumulator.
Carry rags soaked with ammable materials, or carry am-
•
mable liquids in free vessels on the Machine (in engine
bay).
Let the engine run inside conned spaces.
•
Drive with open doors.
•
Perform any adjustments on the machine without the prior
•
consent of the manufacturer.
Drive without the seat belt fastened.
•
Shift electrical conductors.
•
Use other than original spare parts.
•
Interfere in the electrical and electronic units in any man-
•
ner.