Install the lter and tighten with your hand - as per lter •
manufacturer’s data (by 2/3 turn once the lter bears on).
Fuel pre-lter
Disconnect the connector of water separator sensor and •
proceed in the same way like in the previous text. Connect
the sensor connector.
Note
Unless lters are lled with fuels when exchanging them, •
please replenish fuel, refer to the Chapter named ”Clearing
the water separator“.
Use original lters required.
No smoking at work!
Do NOT tighten the lters with force.
Retain any fuel owing out.
Store used lters inside separate con-
tainer, and hand over for their disposal.
To Next Page
Loading...
