Photo 2.6.5
6. When the flag is adjusted re assemble your table. Use the 4 hex screws to level your table. Loosening the
screws will raise your table up tightening the screws will lower your table down. Use the shim and adjust your
screws as needed. If the flag was moved too much you will have to remove your table assembly and adjust
your flag again. When adjusting the table top do the measurements from both sides on the left and the right.
You will also want to check all corners when you move one side as the other side can potentially loose its
position. See Photo 2.6.6
To Next Page
Loading...