Analog way Pulse 2 User Manual

54
It is strongly recommended reseng all of the default values of your Pulse² unit before seng up your shows
and events. This will help eliminate confusion caused by unneeded sengs from a previous operator. To do
so, press the EXIT/MENU buon and select Control in the menu by rotang the corresponding knob. Then
press the ENTER buon to enter the Reset/Erase sub-menu. Select Default Values by rotang the scroll
knob, and press the ENTER buon to enter your choice to restart your Pulse² with its factory sengs. This
operaon should take approximately 30 seconds.
Analog Way engineers have developed a handy, user friendly way of idenfying machine status on the front
panel, via the use of color codes on the buons of the machine. All new Analog Way machines use the same
codes, for quick recognion of the status of any device of the range, at any given me.
For the Pulse², buon color codes are as follow:
• Sources on the Program output are indicated in red when acve,
• Sources on the Preview output are indicated in green when acve,
• Buons in the layer secon turn red or green, depending on whether the selected layer is acve in
respecvely the Program or Preview window,
• menu buons are indicated in green,
• Selecng a buon with an available source or funcon will cause that buon to blink green on the preview,
or red once it is on the Program output,
• TAKE buon reacts as follows:
- If take funcon is available, the buon will appear in green.
- When the take funcon is acve, it will light up red.


8.1.4 Reseng default values

#1 = Source is on the Program output
#2 = Freeze enable

Blinking red:
Blinking green:
#1 = Source is on Preview
#2 = Funcon available for modicaon
#3 = Current output on Matrix mode
Layer/source selected or is currently acve
on the Program output
Layer/source selected or is not currently
acve on the Program output
8.2 
Plug your sources using the 4 mul-plug inputs, 2 HDMI Inputs or 2 3G/HD/SD-SDI inputs.
Be sure that all connectors are rmly aached using all available locking screws.

To set up your inputs automacally:
You can also do it manually on each input# using the ENTER and the Knob buon and set up the inputs type
one by one.
You can also check your actual input conguraon using the cong status: 


Analog way Pulse 2 Specifications

General

Brand	Analog way
Model	Pulse 2
Category	Music Mixer
Language	English