11. SPECIAL OPTIONS
1.1 Installation drain set
Required equipment and tools:
• Crosshead screwdriver
• Drain hose kit [1001347]
1. Remove the plastic plug under the brewer valve and
next to the inlet valve.
2. Remove the drain hoses from the Y-piece and
brewer valve.
3. Connect the short silicone hose to the Y-piece.
4. Connect the 6 mm Teon hose to the ush side of
the brewer valve.
5. Position the plastic sleeve in the hole next to the
inlet valve
6. Feed the long silicone hose behind the boiler and
pump to the sleeve.
7. Connect the drain hose to a drain or jerry can.
8. Remove the drainage reservoir from the machine.
9. Check whether the installed drain set drains the
residual water properly to the drain by making a
number of test drinks.
11.2 Installation OptiBean Hot&Cold
Required equipment:
• OptiBean H&C
• Base cabinet with cooling unit [1001569].
1. Build the cooling unit in the cabinet according the
instructions supplied.
2. Connect the OptiBean to the water (incl. water lter)
and electricity. Connect the cooling system to the
electricity.
3.
Connect the tube which come from the cooling unit
to the push t connectors at the back of the Optibean.
4. Program the cold water recipe onto one of the empty
buttons.
5. Flush and venting the cold water system by dispensing
a number of litres of water.
To Next Page
