SECTION 4 – SYSTEM PLANNING
Detection Circuit Cable (Red Connectors) (Continued)
directly to the main Detection Circuit Cable.
circuit supervision
P-Clamps or double-loop cable ties.
2. Do NOT
such as:
Note:
only use as much Linear Detector as necessary to cover the
less than 2 1/2 in. (64 mm). See Figure 4-3.
used). See Figure 4-3.
-
-
ators and electric motors.
FIGURE 4-3
LINEAR DETECTOR INSTALLATION
Use spot thermal detectors to meet single-point detection
Note: When using spot thermal detectors, plan to locate a
temperature (refer to table).
Rated Maximum
Operating Hazard
Temperature Temperature Detector
vehicle operating and environmental conditions (e.g. shock
and vibration).
CHECKFIRE 110
Detection and Actuation System
64 mm)
EOL
DEVICE
To Next Page
Loading...
