Ansul CHECKFIRE 110 - SECTION 7 - IN CASE OF FIRE; FIRE SAFETY PROCEDURES

SECTION 7 – IN CASE OF FIRE
2014-APR-30 REV. 0 PAGE 7-1
IN CASE OF FIRE
Read these instructions and precautions carefully until they are
clearly understood. All equipment operators or anyone who
has any responsibility for the equipment should understand
how the CHECKFIRE 110 Electric Detection and Actuation
System operates. Every operator should be completely trained
in these procedures.
 -

Note:-
nite the fire with heat or sparks.
 

WARNING
!
           

Automatic Detection and System Actuation
The CHECKFIRE 110 Electric Detection and Actuation
System includes a thermal detection device(s) located in

CHECKFIRE Control Module starts the time delay cycle; at the

suppression system.
Manual System Operation

actuate system.

 


 

 
-
ator.


CAUTION
!
Manual system operation will result in immediate system
        

Automatic Equipment Shutdown
The fire suppression system may be equipped with a pressure
switch. This switch operates when the fire suppression system





is pushed and released before the end of time delay cycle

-



down the vehicle. Note: Press and hold will not pause the time
delay.
WARNING
!

could result in a more difficult fire to suppress.
Exit Vehicle and Move Safely Away


operate system (refer to Manual System Operation in this
section).

move away from the equipment. Stand by with hand portable





DOOR


009241
--------------------------------- OR ---------------------------------
009140

2. STRIKE RED

FIGURE 7-1
IMMEDIATE RELEASE OPTIONS
CHECKFIRE 110
Detection and Actuation System