Chapter 2: Installation
1X-X3 Installation Manual 5
Cabinet installation
Preparing the cabinet
Before installing the cabinet, remove the front cover, and then remove cable
knockouts from the top, bottom, and rear of the cabinet as required.
Where to install the cabinet
Make sure the installation location is free from construction dust and debris, and
immune to extreme temperature ranges and humidity. (See “Mechanical and
environmental specifications” on page 64 for more information on the operating
temperature and relative humidity specifications.)
Allow for enough floor and wall space so the panel can be installed and serviced
without any obstructions. The cabinet should be mounted so that the user
interface is at eye level.
Note that the control panel must be assembled and installed according to the
ordinances and codes that are in effect in your market or region.
Fixing the cabinet to the wall
Fix the cabinet to the wall using five M4 × 30 screws and five 6 mm diameter wall
plugs, as shown below.
To Next Page
Loading...
