Aritech 1X-X3 Installation Manual

Chapter 3: Configuration and commissioning
1X-X3 Installation Manual 25
Table 7: User level passwords and indications
User level Password LED Default display Custom display
Public None None None None
Operator 2222 The Reset LED is
steady
None None
Basic installer 3333 The Reset LED is
flashing fast
Advanced
installer
4444 The Reset LED is
flashing fast
Note: If you have used advanced configuration options to set a custom zone
delay, zone configuration, or zone type, then the seven-segment display defaults
to the custom display operating mode. See “Panel mode” on page 30 for details.
Configuration overview
To facilitate rapid configuration of the most common tasks, configuration is
divided into basic and advanced levels.
For basic configuration options, see “Basic configuration” on page 28. For
advanced configuration options see “Advanced configuration” on page 34.
Note: The Reset and Panel Silence functions are not available when you are in
configuration mode. To reset the control panel or silence the internal buzzer, first
exit from configuration mode. See “Common configuration tasks” on page 27 for
instructions on exiting from configuration mode.
Configuration controls
The control panel is configured using the front panel configuration controls and
the seven-segment display.
The configuration controls
The configuration controls are located on the control panel interface.

Aritech 1X-X3 Specifications

General

Brand	Aritech
Model	1X-X3
Category	Control Panel
Language	English