Aritech 1X-X3 Installation Manual

Chapter 3: Configuration and commissioning
38 1X-X3 Installation Manual
Display Description
Operates as normally closed (NC).
Operates as normally open (NO).
Hold mode
Use this menu to set the operating mode for this device (mode A or B). The
default setting is mode A.
For a description of the emergency MCP Hold function and device, see
“Connecting extinguishing system manual call points” on page 11.
To configure the emergency hold device mode:
1. Set the display as shown below, and then press Enter.
The MCP Hold LED flashes fast to indicate that the configuration menu is
active.
2. Select a value using the value selection buttons (2 and 4).
3. Press Enter.
4. Save your changes.
The available settings for this feature are shown below.
Display Description
Mode A: The actuator delay countdown c
ontinues during
MCP Hold activation.
Mode B: The actuator delay countdown restarts when
the MCP Hold device is restored. MCP Hold is indicated
using a specific sounder tone.
Activation tone
Use this menu to set the extinguishing activation tone of the extinguishing
sounders on the control panel PCB: continuous or pulsed. The pulsed pattern is
1 second on, 1 second off. The default setting is pulsed mode.
To configure the activation tone:
1. Set the display as shown below, and then press Enter.

Aritech 1X-X3 Specifications

General

Brand	Aritech
Model	1X-X3
Category	Control Panel
Language	English