Chapter 3: Configuration and commissioning
1X-X3 Installation Manual 39
The red Extinguishing Sounders LED flashes fast to indicate that the
configuration menu is active.
2. Select a value using the value selection buttons (2 and 4).
3. Press Enter.
4. Save your changes.
The available settings for this feature are shown below.
Display Description
Pulsed mode
Continuous mode
Released tone
Use this menu to set the extinguishing released tone of the extinguishing
sounders on the control panel PCB: continuous or pulsed. The pulsed pattern is
1 second on, 1 second off. The default setting is continuous mode.
To configure the released tone:
1. Set the display as shown below, and then press Enter.
The red Extinguishing Sounders LED flashes fast to indicate that the
configuration menu is active.
2. Select a value using the value selection buttons (2 and 4).
3. Press Enter.
4. Save your changes.
The available settings for this feature are shown below.
Display Description
Pulsed mode
Continuous mode
Extinguishing zones
Use this menu option to define the extinguishing area required for your
installation.
To Next Page
Loading...
