Aritech 1X-X3 Installation Manual

Chapter 3: Configuration and commissioning
28 1X-X3 Installation Manual
The control panel will exit configuration mode after 5 minutes if no button is
pressed.
Visible indications for current value and selected value
Current and selected values are indicated as follows.
Table 9: Visible indications for values
Status Indication
Current value Both decimal points on the display
are steady
New selected value Both decimal points on the display
are flashing
Other value Both decimal points on the display
are off
To restore the previous configuration:
1. Set the display as shown below, and then press Enter.
To restore the factory configuration:
1. Set the display as shown below, and then press Enter.
Basic configuration
The default password for basic configuration is 3333. After entering the
password, the first displayed menu will be Basic default configuration (indicating
the basic installer user level). For more information see “User level passwords
and indications” on page 24.
The basic configuration menu
Configuration options for this menu are shown in the table below. More
information for each option is included in the related topic.

Aritech 1X-X3 Specifications

General

Brand	Aritech
Model	1X-X3
Category	Control Panel
Language	English