Arthrex DualWave User Manual

Product Description
DualWave Arthroscopy Pump User’s Guide
DFU-0212 Rev. 1 Page 12 of 54
Message
Cause
Explanation
−
Button
The operator display shows the pressure reading
until the PRESSURE (-) button is pressed. Once
pressed, the displayed pressure reading will
change to the pressure setting. Each subsequent
press of the pressure button will decrease the
pressure setting in increments of 5.
Pressure set decrease.
RUN Button
Button appears when the pump is stopped. Press
this button to start the pump.
Motors on.
STOP Button
Button appears when the pump is running. Press
this button to stop the pump.
Motors off.
LAVAGE Button
Button appears when the pump is in either
inflow only or inflow/outflow mode. Press the
button and the pump will increase pressure by a
user-defined amount and length of time.
Pressure increased for a set
time.
RINSE Button
Button appears when the pump is in
inflow/outflow mode. Press the button and the
pump will increase outflow by a user-defined
amount and length of time.
Outflow rate and pressure
increased for a set time.
BOOST Button
Button appears when the pump is in inflow only
mode. Press the button and the user may define
the pressure increase when the shaver is
activated.
Pressure increased.
CANNULA Button
Button appears when the pump is in
inflow/outflow mode. Press the button and the
user may define the outflow rate.
Outflow rate change.
SHAVER Button
Button appears when the pump is in
inflow/outflow mode. Press the button and the
user may define the outflow rate of the shaver
and pressure increase. In ASP mode (Alternative
Suction Pathway), the button is red.
Shaver suction change and
pressure increase.
MENU Button
Button appears when the pump is stopped. Press
the button and the pump will enter the setup
menu.
User setups displayed.

Arthrex DualWave Specifications

General

Brand	Arthrex
Model	DualWave
Category	Medical Equipment
Language	English