TD 93119EN
28 June 2016 / Ver. PA5
User Manual
Ascom d63 DECT Handset
31
5.4.12 Conference Call
Prerequisite,
a new call has been started during conversation, see 5.4.7 Start a New Call
during Conversation on
page 29.
NOTE: This option is only visible if configured in the
handset. For more information, see the
Configuration Manual for the handset (TD number: See 17 Related Documents on
page 91).
By initiate a conference call, an conversation can be m
ade between several participants
simultaneously.
1 Press the soft key "More".
2 Select "Conference".
3 Press "Select".
The person initiating the conference call is the conference leader, and the other are
participant mem
bers of the conference call.
5.4.13 Call Back
When a call is made to a busy handset, an automatical
ly call back can be made when the
busy handset is free.
NOTE: This option is only visible if configured in the
handset. For more information, see the
Configuration Manual for the handset (TD number: See 17 Related Documents on
page 91).
When a busy tone sounds, do as follows:
1 Press the soft key "More" during the call.
2 Select "Call back".
3 Press "Select".
4Press
and wait until the handset alerts.
5 When the handset alerts, press
. The call is started automatically.
5.4.14 Send Call Waiting
This function is used when a ca
lling party receives a busy signal from a party engaged in a
call and wishes to notify the party that another call is waiting. To notify the engaged party:
1 Press the soft key "More".
2 Select "Call waiting"
.
3 Press "Select". The engaged party receives a "Call waiting" signal.
When the line is free it automatically calls the number again. This is system dependent.
Note: The "Call waiting" function is only visible if an
administrator has activated it in the
handset. For more information, see the Configuration Manual for the handset (TD number:
See 17 Related Documents on
page 91).
To Next Page
Loading...
Need help?
General
