TD 93119EN
28 June 2016 / Ver. PA5
User Manual
Ascom d63 DECT Handset
6
Battery
The battery is a rechargeable Li-pol battery, placed under a battery cover. See 15.1.4
Replace the Battery on pag
e 84.
The battery is fully charged within four hours. See 15.1.2 Charge the Battery on
page 84.
The battery can be charged separately with a special battery charger. See 15.1.3 Charge
Spare Batteries on
page 84
2.2 Chargers
2.2.1 DC3 Desktop Charger and DP1 Desktop Programmer
Figure 2. DC3 Desktop Charger and DP1 Desktop Programmer.
The DC3 Desktop Charger will only charge the handse
t, while the DP1 Desktop Programmer
will download new software and synchronize parameters. The handset is fully operational
while placed in the charger.
The DC3 Desktop Charger is delivered with a plug-in p
ower supply and is connected into an
ordinary wall socket.
NOTE: Only use the charger within the temperature range of +5° C – +40° C.
2.2.2 CR3 Charging Rack
The CR3 Charging Rack is used for charging several handsets, to synchronize parameters,
and for sof
tware download.
The built in power supply can charge up to six handsets.
See the Installation and Operation Manual for CR3 Charging Rack.
2.2.3 Battery Pack Charger
The Battery pack charger is used for ch
arging up to six spare batteries.
To Next Page
Loading...
Need help?
General
