TD 93119EN
28 June 2016 / Ver. PA5
User Manual
Ascom d63 DECT Handset
42
messages. In figure 7 on page 42, there are two colored messages, a new message and a
read message, in the message inbox (left in th
e figure). The messages are indicated by a
gradient color bar behind the envelopes. In addition, a gradient color bar is shown below the
envelop when reading a colored message (right in the figure).
Figure 7. Shows an example of a colored message.
To enable colored messaging, see the corresponding manual
for the application used. In
addition, colored labels can be mapped to message beep codes. See the Installation and
Operation Manual for Device Manager.
6.10 Decline a Call with a Predefined Message
A call may be declined with a predefined message by the called party provided that both
parties are connected via a DECT system. To decline a call with a predefined message when
the handset rings, perform the following steps:
1 In response to the "Reply with a message tem
plate?" prompt, press the "Yes" soft
key to send a message to the caller. A list of predefined messages is displayed in the
"Templates" menu.
2 Select, and if required, edit the message as described in The Templates Menu on
page
38.
3 Click the soft key "Send". The calling party num
ber is displayed in the handset
display.
4 Click the soft key "Send". A "Message se
nt" confirmation is displayed and the
message is sent to the caller.
6.11 Answering a Text Message with a Predefined Message
To respond to an incoming text message with a predefined message, perform the following
steps:
1 Press the soft key "Reply"
2 Press the "More" soft key. The "Tem
plates" option is displayed.
3 Press the soft key "Select". A list of predefined message
templates is displayed.
4 Navigate to the required message template and press the "Select" soft key. If
required
, edit the message as described in The Templates Menu on
page 38.
5 Press the soft key "Send". The message sender
’s number is displayed in the handset
display.
6 Press the soft key "Send". A "Message sent" confirmation is displayed a
nd the
message is sent to the caller.
To Next Page
Loading...
Need help?
General
