TD 93119EN
28 June 2016 / Ver. PA5
User Manual
Ascom d63 DECT Handset
33
5.4.17 DECT Info
DECT info is an advanced function int
ended for an administrator using the handset to
measure RF link and system parameters as part of a troubleshooting or site surveying
procedure. This option is only visible if the Admin menu is activat
ed as described in section
11.1 Admin Menu on
page 77. For more information, see the Configuration Manual for the
handset (TD number: See 17 Related Documents on
page 91).
5.4.18 Send Data
User entered data can be sent from the handset by press
ing a pre-programmed hot key or
soft key, or selecting a Service. Sent data can be used to initiate actions such as opening a
door or starting and stopping a machine. The data can either be predefined, entered after
the hot key or soft key is pressed, or send when the relevant service is selected.
5.5 Loudspeaking Function
There are five options to activate the loudspeaking function:
• Press a Multifunction button, Navigation key, Hot key or Soft key defined as shortcut
to a
"Phone call
" function. When pressing the key/button, a predefined number is called,
see 8.3 Shortcuts on
page 59.
NOTE: The support for Multifunction button is depende
nt on what model of handset that
is used. For more information, see 1.2 Functions and Accessories on
page 2.
• When receiving a call, press the soft key
. The Soft key might have another/no
function depending on its configuration of the In call function in WinPDM/Device
Manager.
• During a call, press the soft key
. The Soft key might have another/no function
depending on its configuration of the In call function
in WinPDM/Device Manager.
• During a call, put the handset in a charger. Requires that L
oudspeaking is chosen in the In
Charger menu.
• This function can also be activate
d by selecting another answering method, that is,
"Automatically" and/or "Loudspeaking". See 8.8.6 Answering on
page 73.
5.6 Call Diversion
All calls; internal calls, external calls, calls when busy, or calls at no answer can be diverted to
another handset number. The diversion is made via the Calls menu > Call services > Divert
calls. See Divert Calls on
page 58.
In addition, an absence reason (for example “Lunch”,
“Meeting”, “Trip” etc.) can also be set.
The absence reason is set via the Calls menu > Call services > Absence. See 8.2.9 Call
Services on
page 57.
NOTE: PBX settings for the call diversion must be set in order to sh
ow the Divert calls menu
in the handset. See the Configuration Manual for the handset (TD number: See 17 Related
Documents on
page 91).
NOTE: If both diversion and absence reason are set, the ab
sence reason is used.
Either can a Multifunction button, Soft key or H
ot key be preprogrammed with a shortcut to
the diversion function or the absence reason/menu. See 8.3 Shortcuts on pa
ge 59.
NOTE: The support for Multifunction button is dependent on what model of handset that is
used. For more information, see 1.2 Functions and Accessories on
page 2.
To Next Page
Loading...
Need help?
General
