Quick Installation Steps for Administrators
User Manual
Ascom Myco Smartphone
2 Quick Installation Steps for Administrators
An administrator should perform the following steps to get the handset started:
Remove the protective plastic sheet attached to the display, for proper function of the touchscreen.
1. Insert the micro-SIM card (Cellular handset versions only). See 2.1 Insert SIM Card, page 4.
Only a micro-SIM size card can be used in the handset.
2. Close the battery cover, and lock it. See 4.11 Change the Battery, page 24.
The battery has an approximately 50% charge at delivery, and does not need to be charged
before use.
3. Change the language (if other than the default english). See 16.3 Languages Settings, page 84.
4. Enter the handset ID (Easy deployment). See 2.2 Install and Configure the Handset, page 4.
If not already done as prerequisite, perform Easy deployment. See the Configuration Manual,
Ascom Myco Smartphone.
5. Configure parameter settings for the site, or for the handset user. See the Configuration Manual,
Ascom Myco Smartphone for further information.
2.1 Insert SIM Card
Cellular handset version only. Only micro-SIM size cards can be used in the handset.
1. Unlock the battery cover lock, and then remove the battery from the handset.
2. The SIM card slot is located under the clip. Press the upper part of the clip to open it fully, and insert
the micro-SIM in the SIM card slot, in the direction as shown on the label.
TIP: If needed, use a tweezer to hold the SIM card, and then push it into the slot.
3. Close the battery cover, and then lock it. The handset starts within seconds, if the battery is charged.
TIP: If the handset does not start, charge the battery, then long press the Power button to turn the
handset On.
Remove SIM Card
1. Open the battery cover lock. Press the clip to open it fully, and remove the Battery Pack.
2. Remove the micro-SIM card by using a 3-4 mm screwdriver, or similar tool, in the hole above the SIM
card slot, and pull outwards, until the micro-SIM card can be removed (with your fingers, or with a
tweezer).
Be careful not to damage the inside of the SIM card slot.
2.2 Install and Configure the Handset
The recommended method to install and configure a handset is through Easy Deployment, by using a pre-
configured staging WLAN. If Easy Deployment is not configured in the system, use QR code and NFC setup,
or install the handset manually through the admin settings menu.
4
TD 93066EN / 14 December 2018 / Ver. N
To Next Page
Loading...
