User Manual
Ascom Myco Smartphone
Maintenance
18 Maintenance
This chapter includes the following sections:
• 18.1 Cleaning the Handset, page 87
• 18.2 Battery Maintenance, page 87
• 18.3 Replace the Color Pad for the Hinge-Type Clip, page 87
18.1 Cleaning the Handset
Chemical Resistance
The exterior of the handset has been tested and found resistant to chipping, fading, or wearing off, when
the handset is treated with common cleaners, disinfectants, or perspiration. The following chemicals are
safe to use for cleaning the handset:
• 3 % Hydrochloric Acid
• M-alcohol (85 % Methylated Ethanol)
• 60 % Chlorhexidine 0.5 mg/m
Avoid using acetone to clean the handset, as it damages the handset's plastic casing.
18.2 Battery Maintenance
Battery Life
See the Battery Storage and Maintenance Guidelines, For Ascom LiIon/LiPol battery packs document.
18.3 Replace the Color Pad for the Hinge-Type Clip
Pads with different colors can be attached to the hinge-type clip for easy identification of the handset. The
different colors can, for instance, represent a workgroup or a shift.
18.3.1 Remove the Color Pad
1. On the back of the hinge-type clip, the colored pad is fastened with tabs in two places. Use a paper clip,
or a thin 3-4 mm flat screwdriver, to push against one of the tabs.
2. Once the colored pad bulges slightly outward (when applying slight pressure to one of the tabs on the
back of the colored pad) use a finger to pull downward from the center of the colored pad until the pad
comes off.
18.3.2 Attach the Color Pad
1. Align the colored pad with the cut-out for the pad on the hinge-type clip.
2. Attach the pad by pushing down on one end of the pad first. Then do the same thing on the other end
of the pad. Make sure that the color pad is flush to the clip.
TD 93066EN / 14 December 2018 / Ver. N 87
To Next Page
Loading...
