Troubleshooting
User Manual
Ascom Myco Smartphone
19 Troubleshooting
This chapter contains information on how to solve common problems and warning messages.
Go through the lists below if you encounter any problems. If these lists does not solve your problem,
contact your system administrator.
If other handsets are having similar problems, it might be a system error.
This chapter includes the following sections:
• 19.1 Operational Problems, page 88
• 19.2 Warning Messages, page 89
19.1 Operational Problems
Fault Probable Cause Action/Comment
No network.
The handset beeps once a
minute (for max 30 minutes) in a
low tone, followed by a high tone
(if enabled, the vibrator also
follows the beeps).
The handset has lost connection
and is in one of the following
states:
- No network
- No access
- Voice only
- Messaging only
Acknowledge the warning
notification or, press the Volume
down button (the later keeps the
dialog window visible).
You can configure the beep to
Sound off, or Sound once (for
each new state), contact the
system administrator.
Note: When leaving a bad state
for another bad state, the
warning notification reopens, and
the beep sounds again (if
enabled).
Nothing is displayed on the front
display.
The battery is empty, the screen
is broken, or the handset is
defective.
Charge/replace the battery, or
contact the system administrator.
Front display is too dark. Brightness is too low, or on
automatic.
Manually select the brightness
level.
See 16.1.1 Change Brightness,
page 82.
No ringtone when a call is
received, or no sound when an
alert/notification is received.
The ringtones and notifications
volume is silent, or vibrator only,
or the loudspeaker is defective.
Increase the volume by pressing
the Volume up button, or by
adjusting the slider in
Settings > Sound > Volumes >
Ringtones & notifications, or
contact the system administrator.
Not possible to select a louder
ring volume than Silent.
Minimum volume is configured
as a value other than Silent (no
restriction), restricting the
handset from setting the volume
to silent.
Ask an administrator to change
the Minimum volume parameter
to Silent (no restriction)
See the Configuration Manual,
Ascom Myco Smartphone.
88 TD 93066EN / 14 December 2018 / Ver. N