ASCOM Myco - Alerts Handling

User Manual
Ascom Myco Smartphone Calling
TIP: Tap the Hang Up icon to disconnect the call.
5.4.11 The Phone Bar
Call status is shown through a phone bar in the lower part of the screen while navigating the user interface.
• Tap the icons on the phone bar to interact directly with the call (for example to accept/end the call, or to
push-to-talk).
• Tap the middle of the phone bar to open the call screen.
Figure 34. Phone bar showing an incoming call
5.5 Headset
19
A headset can be used for any type of call on the Ascom Myco 2 handset. The original Ascom Myco
Headset or any Android compatible 3.5 mm headset can be used
20
.
Caution
An iPhone headset can not be used with the Ascom Myco.
The headset connector for an iPhone looks the same as the headset connector for Android, but
the electrical internals in the headset, specifically for the microphone, differ from an Android
compatible headset.
5.5.1 Connect the Headset
In order to connect the headset to the handset, do the following:
• Connect the Ascom headset adapter to the charging-/headset connector.
• Connect the headset to the adapter.
5.5.2 Answer or Reject a Call with the Headset
To answer a call with the headset, short-press the main headset button. To reject a call, long-press the main
headset button. To answer a call without using the headset, see 5.1 Answer or Reject a Call, page 34.
5.5.3 Headset Functions During a Call
A short press on the main headset button, while in a call, will hang up the call. A long press on the main
headset button will mute the mic (a long press on the main headset button, with the screen on and outside
of a call, will start voice control of the handset).
5.5.4 Make a Call with the Headset
To initiate a call, follow the instructions in 5.2 Make a Call, page 35. The headset itself cannot be used to
initiate a call.
5.5.5 Adjust the Volume with the Headset
To adjust the volume with the headset, press the volume button up or down on the headset. To adjust the
volume without using the headset buttons, see 4.3 Adjust the Volume, page 15.
TD 93066EN / 14 December 2018 / Ver. N 43
19. Only available for Ascom Myco 2.
20. Requires the use of the Ascom headset adapter (item number 660511).