ASCOM Myco - Charge the Handset in a Charging Rack; Charge the Battery in a Battery Charging Rack

Basics
User Manual
Ascom Myco Smartphone
Handset Charging Rack: Approx. 3.5 hours
Micro USB cable with recommended Power supply
unit in a wall socket:
Approx. 4.5 hours
Micro USB cable in a switched on PC: Approx. 4.5 hours
4.10.1 Charge the Handset in a Charging Rack
TIP: The handset can be configured to clear all existing messages and alerts, mute the loudspeaker, or to
automatically log out the user when placed in a Charging Rack, see the Configuration Manual, Ascom Myco
Smartphone.
1. Place the handset in a Charging Rack slot. The charging screen appears as soon as the handset is
correctly inserted, and shows the current charge level, see 4.10.4 Charging Indication, page 23.
2. Allow the handset to charge fully. It takes approximately 3.5 hours with a fully depleted battery.
The handset is fully charged, and ready to use, when the charging screen shows 100%, and the top
LED light is fixed green.
TIP: We recommend to always charge the battery fully to extend the battery life, although no harm is
made to the handset, if removed from the Charging Rack before the battery has been 100% recharged.
3. To remove it from the Charging Rack, lean the handset forward slightly and pull.
If the handset is switched off when it is placed in the charging rack, it will automatically switch on
in charger mode once the battery level has reached a sufficient level.
1
1. This only applies to Ascom Myco 2, whereas the previous model will not automatically switch on in charger mode.
4.10.2 Charge the Battery in a Battery Charging Rack
TIP: For instructions on how to remove and insert the handset battery, see 4.11 Change the Battery, page 24.
1. Place the Battery Pack in one of the Battery Charging Rack slots.
2. Slide the battery lock to the left.
The LED light under the slot turns red when the battery is correctly inserted.
3. Allow the battery to charge fully. It takes approximately three hours with a fully depleted battery.
The handset is fully charged, and ready to use, when the charging screen shows 100%, and the top
LED light is fixed green.
TIP: We recommend to always charge the battery fully to extend the battery life. Although, there is no
harm made to the battery if removed from the Battery Charging Rack before it is charged completely,
that is, when the LED light beneath the slot still shows red.
4. Slide the battery lock to the right.
5. Remove the battery by lifting it up.
The Battery Pack can be difficult to remove from the slot the first few times of usage.
22
TD 93066EN / 14 December 2018 / Ver. N