134 G12 OEM Board & Sensor Reference Manual
RCI: Set Output Interval for Raw Messages
$PASHS,RCI,f1
This command allows you to set a global output interval for all raw messages, where
f1 is the value for the output interval. Use Table 4.66 to determine the value for f1.
This command overrides individual settings for output interval. That is, if the CT1
message is enabled for output at intervals of two seconds and the MBN message
is enabled for output at intervals of ten seconds, you can ese the RCI command to
set an output interval of five seconds and reset the output interval of both messages
to five seconds. You can view the current raw data output interval setting by entering
the $PASHQ,RAW command and checking the RCI field.
Example
Enter the following command to set the global raw data output interval to 5 seconds:
$PASHS,RCI,5
PRTA
PRTB
Communication Ports A and B
OFF/ON OFF indicates that the RAW data message is not sent to the port.
ON indicates the RAW data message is sent to the communication
port.
Table 4.66. Raw Data Update Rate Options and Settings
Installed
Option
Option
Symbol
RCI Range
(seconds)
Increment
1 Hz 1 1-999 1 second
2 Hz 2 0.5-999 0.5 second from 0.5 to 1
1 second from 1 to 999
5 Hz 5 0.2-999 0.2 second from 0.2 to 1
1 second from 1 to 999
10 Hz T 0.1-999 0.1 from 0.1 to 1
1 from 1 to 999
20 Hz W 0.05-999 0.05 from 0.05 to 0.1
0.1 from 0.1 to 1
1 from 1 to 999
Table 4.65. $PASHQ,RAW Response Parameters
Field Description
G12RevD.book Page 134 Tuesday, April 2, 2002 4:33 PM
To Next Page
Loading...