ashtech G12 - Corporate Web Page

197
Commands
$PASHS,RTC,SEQ,Y
SPD: Baud Rate for RTCM Message Output
$PASHS,RTC,SPD,d1
This command allows you to set the base station’s output rate for RTCM messages
in bits per second (bps), where d1 is a code number between 0 and 8. Table 4.119
lists the available bit rates and corresponding codes. The default output bit rate is
300 bps. This command applies to base station mode only. You can view the current
output bit rate setting by entering the $PASHQ,RTC command and checking the
SPD field.
Example
Enter the following command to set the output bit rate for RTCM messages to 1500
bits per second:
$PASHS,RTC,SPD,8
DEFAULT SETTING
RTC,SEQ— N
Table 4.119. Available Output Bit Rates for RTCM Messages
Code Rate
025
150
2 100
3110
4 150
5 200
6 250
7 300
8 1500
DEFAULT SETTING
RTC,SPD— 300
G12RevD.book Page 197 Tuesday, April 2, 2002 4:33 PM