68 G12 OEM Board & Sensor Reference Manual
Example
Enter the following command to set the G12 in fixed altitude mode 1:
$PASHS,FIX,1
FUM: Fix UTM Zone
$PASHS,FUM,c1
This command enables/disables the fixing of the UTM zone, where c1 is Y (enable)
or N (disable). The default is N. This command is typically enabled when the user
is near a UTM boundary and wants to avoid the coordinate shift that occurs when
crossing from one UTM zone into another. This command is used in conjunction
with the $PASHS,FZN command which is used to select the zone to be fixed by
the FUM command.
Example
Enter the following command to enable the fixed zone setting:
$PASHS,FUM,Y
FZN: Select Fixed UTM Zone
$PASHS,FZN,d1
This command allows you to select the UTM zone that will be held fixed, where d1
is the UTM zone number ranging from 1 to 60. This command is typically used when
the user is near a UTM boundary and wants to avoid the coordinate shift that occurs
when crossing from one UTM zone into another. This command is used in
conjunction with the command $PASHS,FUM, which holds fixed the zone selected
by the FZN command.
Example
Enter the following command to select UTM zone 10 as the zone to be held fixed:
$PASHS,FZN,10
DEFAULT SETTING
FIX—Mode 0
DEFAULT SETTING
FUM—N
G12RevD.book Page 68 Tuesday, April 2, 2002 4:33 PM
To Next Page
Loading...