59
Commands
Example
Set doppler averaging time interval to 5 seconds:
$PASHS,DAP,5
$PASHQ,DAP,[c1]
This command queries the doppler averaging interval range, where c1 is the optional
port designator for the output of the response. If a port is not specified, the receiver
sends the response to the current port.
$PASHR,DAP
The response message is output in the format:
$PASHR,DAP,f1*hh
where the DAP parameters are as defined in Table 4.10.
DFO: Remote Station Status
$PASHQ,DFO,[c1]
This command queries the remote station status, where [c1] is the optional port
designator for the output of the response. If a port is not specified, the receiver
sends the response to the current port.
$PASHR,DFO
The response is in the format:
$PASHR,DFO,d1,d2,d3,d4,d5,d6,d7,{di,+/-fi1,+/-fi2}1-n
Table 4.10. $PASHR,DAP Format
Parameter Description Range
f1 Doppler averaging interval 0.0 to 5.0
hh Checksum 2-character hex
G12RevD.book Page 59 Tuesday, April 2, 2002 4:33 PM
To Next Page
Loading...