198 G12 OEM Board & Sensor Reference Manual
STH: Differential Base Station Health
$PASHS,RTC,STH,d1
This command allows you to set the health of the base station, where d1 is a code
number between 0 and 7. The health states and the corresponding codes are listed
in Table 4.120. This command applies to base station mode only. You can view the
current base station health setting by entering the $PASHQ,RTC command and
checking the STH field.
Example
Enter the following command to set the base station health code to indicate that
the base station is not working:
$PASHS,RTC,STH,7
STI: Differential Base/Remote Station ID
$PASHS,RTC,STI,d1
This command allows you to set differential station identification numbers, where
d1 is any number between 0000 and 1023. A remote station with the ID number
0000 can receive corrections from any RTCM base station; otherwise, the remote
station must be programmed with the same ID number as the base station in order
to receive corrections from that base station.
Table 4.120. $PASHS,RTC Health of Reference
Code Base Station Health Status
7 Reference station not working
6 Reference station transmission not monitored
5 Specified by service provider
4 Specified by service provider
3 Specified by service provider
2 Specified by service provider
1 Specified by service provider
0 Specified by service provider
DEFAULT SETTING
RTC,STH— 0
G12RevD.book Page 198 Tuesday, April 2, 2002 4:33 PM
To Next Page
Loading...