Getting Started 19
This section is intended to get you started using the G12 receiver. Please refer to
the chapters on General Information, Operation, and Command/Response
Formats for specific details regarding performance, power requirements, and
commands.
This chapter discusses the following topics:
• Connecting the G12 to power, connecting the antenna, and equipment
used for receiver control and data logging.
• Default parameters.
• Communicating with the G12 using standard communications software
and an IBM-compatible PC.
• Sending common commands to the G12.
G12RevD.book Page 19 Tuesday, April 2, 2002 4:33 PM
To Next Page
Loading...