24 G12 OEM Board & Sensor Reference Manual
4. If interfacing through port A, type $PASHS,NME,SAT,A,ON,1 and press
<Enter>. This command tells the G12 to return locked satellite information
through port A at a set rate. The response message output rate is 1 Hz
(default):
$PASHR,SAT,03,03,103,56,60,U,23,225,61,39,U,16,045,02,21,U*6E
The data string contains the number of SVs locked plus the elevation,
azimuth, and signal strength for each locked SV, and also indicates whether
a given satellite is used (U) or not used (-). Chapter 4 contains details on
these commands and responses, as well as the rest of the commands and
responses supported by the G12.
G12RevD.book Page 24 Tuesday, April 2, 2002 4:33 PM
To Next Page
Loading...