ASIX Forte - 8.3 Running JTAG Player from Command Line

Page 96
RUNTEST timing multiply (both SVF and XSVF):
25%
RUNTEST with run_count and no timing (both SVF
and XSVF): interpret as RUNTEST min_time with scale
1MHz
VPP PRESTO / P FORTE pin usage while running test
(file): Tristate
VPP PRESTO / P FORTE pin usage after test
completion: Tristate
8.3
Running JTAG Player
from Command Line
SVF & XSVF JTAG Player can be run from the command
line for more comfort especially during debugging. The
following parameters apply:
jtagplay.exe [-p] [-f filename] [-i inifile] [-
c] [-cc] [-s serial]
-p automatically executes the file specified in
the -f filename parameter
-f filename specifies SVF / XSVF file to be executed
-i inifile ini file containing settings
-c closes the program if the file has been
executed without errors
-cc closes the program even if the file has been
executed with error(s)
-s serial uses PRESTO or FORTE programmer of the
specified serial number
-forte uses FORTE, not PRESTO
Return Codes
The jtagplay.exe program returns the following return
codes:
0 execution of the last file had no errors
1 an error occurred during execution of the
last file
2 execution of the last file could not be
started