Page 97
9
MultiUP
MultiUP is utility usable for programming with up to 4
ASIX programmers at once. MultiUP uses program UP.
The utility is installed together with the UP program.
MultiUP can simply, using one button, run programming
of selected task, which is deffined with the UP program
project and other settings.
To increase speed the utility loads the programming data
only once, it is suitable for using in production.
9.1
Programming settings
In the "Options/Programming settings" it is possible to
select programmers to be used, UP program project to be
programmed, whether they will program the common
way or using the differential programming and the
memories to be programmed.
To improve clarity it is possible to select a name for each
of the programmers.
Each of the programmers can program a different project
or all of them can be the same project.
All of the programmers do not have to be of the same
type (PRESTO, FORTE), but the selected project have to
use the same type of the programmer.
In the Options it is also possible to select Keyboard
shortcuts for running work of the praticular programmers
and to set the console saving during the program closing.
The parameters configured in the Options can be used
once or they can be saved to MPPR file for other using.
9.2
Programming
For programming of predefined tasks it is advisable to
open MultiUP project file in menu "File/Open MPPR file".
The project can be crated in the "Options" menu.
Afterwards the particular programmings can be run
separately using the "Run" button on the appropriate
programmer panel or all the active programmings can be
run at once using the "Run all" button, eventually the
associated keyboard shortcuts can be used.
9.3
CommandLine
It is possible to provide the MPPR project path on the
commandline, it will be loaded on the utility start.
Example:
multiup.exe C:\data\project.mppr
To Next Page
Loading...