Assa Abloy Effeff 519 - Safety Instructions

48
EN
Information
Safety instructions
Warning!
Diminished fire protection function may result in personal injury and property damage: Fire doors
prevent fire from spreading and are tested as a complete unit with accessories:
· regulations established by inspection authorities must be complied with,
· Check whether the door certification matches the lock.
· The door manufacturer must be consulted if the lock is to be replaced with a different model or if a lock
is to be retrofitted. Specifications of the door manufacturer must also be observed.
· the installed lock must be the appropriate size.
Danger resulting from damage: A damaged device is a safety risk and may not be put into operation.
Check the packaging and the device for damage. Damaged cables and connector assemblies must not be
used either.
Attention!
Property damage from work on the door leaf: The lock must be removed for any work on the door leaf,
such as drilling or cutting.
Impaired function due to incorrect rebate gap: The rebate gap must be appropriately adjusted
(“Technical data”, page76, Pic. 4).
Property damage due to unsuitable striking plate: The striking plate must be selected
(“Striking plates”, page78) and mounted in such a manner that it always acts as the stop face and slid-
ing surface for the latch.
Property damage due to improper handling during transport: The door leaf may not be lifted or carried
by the door handles.
Property damage from opening the lock: Open the lock will damage it and void the warranty
(„Warranty“ auf Seite 80).
Property damage from painting: Do not paint the lock or striking plate, or coat either with other sub-
stances.
Water and moisture will cause material damage: The lock must be protected to prevent water from get-
ting inside of it. Water may impair functioning and destroy the lock.
Observe the EMC Directive: For reasons of electromagnetic compatibility, individual cables may not be
connected in parallel in order to maintain a large conductor cross-section. Always use individual cables
with the appropriate cross-section surface.
!
A