66
EN
Installation
DIP switch
DIP
switch
Description of switch position (factory setting ON / OFF in bolt)
1 OFF Switch must be set
to OFF
2 ON Bus terminating resis-
tor switched on
A device with a bus terminating resistor must be provided in a CAN-
BUS network.
OFF Bus terminating resis-
tor switched off
3 ON Alarm switched on at
escape door
(Escape door control
unit)
If the lock is unlocked in the escape direction (from inside) and the
door is opened, the door can be passed through for 30 seconds. If the
door is open for prolonged periods of time, then the Alarm fault control
output will be activated and the Pre-alarm status will be triggered for
an additional 30 seconds. The Pre-alarm status can be reset during this
time by closing the door. IF the door remains open, a main alarm is trig-
gered and the Alarm fault control output can only be reset by means of
an Unlock signal
Escape door function Door handle actuated, control output (relay) does not switch
Profile cylinder contact actuated, control output switched.
Permanent unlocking (office function) and toggle function are not pos-
sible in escape door control functional mode.
OFF Alarm switched off at
escape door
(Access control)
If the lock is unlocked in the escape direction (from inside), the control
unit does not issue an alarm.
Access control Door handle or profile cylinder actuated, control output switched
4 A swing door drive may not start before the motorised multi-point lock
519 is unlocked.
ON The UII control
module controls the
unlocking process
Sequence of the door opening process:
1. The motorised multi-point lock 519 receives an opening signal and
unlocks.
2. Swing door drive control output (Tab. 8) sends the Drive message.
3. The swing door drive opens the door.
The swing door drive control output (Tab. 8) is reset when the door has
been opened (message via the striking plate sensor)
.
OFF The swing door drive
controls the unlock-
ing process
Sequence of the door opening process:
1. The swing door drive receives an opening signal.
2. The swing door drive sends a signal to the motorised multi-point
lock 519 (unlocking control input).
The swing door drives waits for the message Drive on from the motor-
ised multi-point lock 519.
3. The Swing door drive control output (Tab. 8) sends the message
Drive on and remains in this status as long as the door is open.
4. The swing door drive opens the door.
Tab. 7 :
Configuration via DIP
switch
4132
ON
OFF
DIP
(factory setting)
To Next Page