Answering system
157
Answering system settings
Remote access code
To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access code
is 19.
To change the remote access code:
Using a cordless handset:
1. When the handset is in idle mode, press MENU to enter the
main menu.
2. Press
CID or
DIR to scroll to Answering sys, then
press SELECT.
3. Press
CID or
DIR to scroll to Ans sys setup, then
press SELECT
4. Press
CID or
DIR to scroll to Remote code, then
press SELECT.
5. Use the dialing keys to enter a two-digit number. Press
MUTE/DELETE to backspace and delete a digit.
6. Press SAVE to save the setting. You hear a confirmation tone.
Using the telephone base:
1. When the telephone base is in idle mode,
press MENU to enter the main menu.
2. Press SELECT to select Answering sys.
3. Press qCALLER ID or pDIRECTORY to scroll to
Ans sys setup, then press SELECT.
4. Press qCALLER ID or pDIRECTORY to scroll to
Remote code, then press SELECT.
5. Use the dialing keys to enter a two-digit number. Press
X/DELETE to backspace and delete a digit.
6. Press SAVE to save the setting. You hear a confirmation tone.
SELECT
ANS SYS SETUP
Call screening
# of rings
Remote code
BACK
REMOTE CODE
19
SAVE
BACK
ANS SYS SETUP
Call screening
# of rings
Remote code
BACK SELECT
REMOTE CODE
19
BACK SAVE
To Next Page
Loading...
