AT&T CLP99587 - Multiple Handset Use

Multiple handset use
74
Intercom
Use the intercom feature for conversations between two handsets, a
handset and the telephone base, or a handset/telephone base and a cordless
headset/speakerphone (sold separately). You can buy additional expansion
handsets (model AT&T CLP99007), cordless headsets and speakerphones for
this telephone base to expand your telephone system (up to 12 handsets or
10 cordless handsets and two cordless headsets/speakerphones).
Using a cordless handset:
1. Press MENU in idle mode to enter the main menu. Press

CID or

DIR to scroll to Intercom, then press SELECT.
f If you have one handset and no other registered devices,
the handset shows Calling base.
f If you have other registered device(s) or more than
one handset, the handset shows INTERCOM TO:. Use
the dialing keys to enter a specific device number (0
for the telephone base, 1-9 for handsets 1-9, TONE
followed by 0-2 for handsets 10-12, or # for a single
headset/speakerphone, # followed by 1 or 2 for headset/
speakerphone 1 or 2, or TONE followed by
#
for all
devices), or press

CID or

DIR to scroll to the desired
device and press SELECT. Your handset screen shows
Calling HANDSET X, Calling BASE 0, Calling headset or
Calling all devices.
The destination device(s) rings and shows HANDSET is calling, HANDSET
X is calling or HANDSET X is calling all (HANDSET represents the handset
name, X represents the handset number).
2. To answer the intercom call, press HOME/FLASH, /SPEAKER, CELL 1 ,
CELL 2 or any dialing key (0-9, TONE ) on the destination handset, or press
HOME on the telephone base. Both devices now show Intercom.
3. To end the intercom call, one party presses END, OFF/CANCEL, or places
the handset back in the telephone base or charger; or one party presses
END on the telephone base. The other party hears four beeps. Both
devices display Intercom ended.
SELECT
Smart call blk
Directory
Caller ID log
Intercom
BACK S
BACK
BACK
SELECT
INTERCOM TO:
BASE 0
HANDSET 2
All
CK S