AT&T CLP99587 - Message Alert Tone

Answering system
158
SELECT
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
BACK
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
BACK SELECT
Answering system settings
Message alert tone
When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every ten seconds. Unless you change it,
the message alert tone is set to o.
There is no audible alert at the handset.
To change the setting:
Using a cordless handset:
1. When the handset is in idle mode, press MENU to enter the
main menu.
2. Press

CID or

DIR to scroll to Answering sys, then
press SELECT.
3. Press

CID or

DIR to scroll to Ans sys setup, then
press SELECT.
4. Press

CID or

DIR to scroll to Msg alert tone, then
press SELECT.
5. Press

CID or

DIR to choose On or Off.
6. Press SELECT to save the setting. You hear a
confirmation tone.
Using the telephone base:
1. When the telephone base is in idle mode, press MENU
to enter the main menu.
2. Press SELECT to select Answering sys.
3. Press qCALLER ID or pDIRECTORY to scroll to
Ans sys setup, then press SELECT.
4. Press qCALLER ID or pDIRECTORY to scroll to
Msg alert tone, then press SELECT.
5. Press qCALLER ID or pDIRECTORY to choose On or Off.
6. Press SELECT to save the setting. You hear a confirmation tone.
Notes:
f The message alert tone beeps only if all the following conditions are met:
- Answering system is on.
- Message alert tone setting is on.
- There are new messages.
f To temporarily turn off the message alert tone, see page 163.
SELECT
MSG ALERT TONE
On
 Off
BACK
MSG ALERT TONE
On
Off
BACK SELECT