Appendix
208
California Energy Commission battery charging testing instructions
This telephone is set up to comply with the energy-conserving standards right out of the box. These
instructions are intended for California Energy Commission (CEC) compliance testing only. When the
CEC battery charging testing mode is activated, all telephone functions, except battery charging,
will be disabled.
To activate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet. Make sure all cordless handsets
are inserted with charged batteries and out of the chargers before proceeding.
2. While you press and hold /HANDSET LOCATOR, plug the telephone base power adapter back to
the power outlet.
3. Aer about 20 seconds, when the HOME light starts ashing, release /HANDSET LOCATOR and
then press it again within two seconds. You hear a conrmation tone. The HOME light turns o and all
handsets display To register HS, see manual.. Allow up to one minute for the process to complete.
If the phone fails to enter this mode, repeat all the steps mentioned above. The telephone base
will be powered up as normal if you fail to press /HANDSET LOCATOR within two seconds in
Step 3.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back in. The
telephone base is powered up as normal.
2. Register your handsets back to the telephone base. See pages 170-171 for handset
registration instructions.
BC
To Next Page
Loading...
Need help?
General
