Getting started
17
1. Plug the telephone line into the telephone base. If you are using a DSL
lter, plug the other end of the telephone line into the lter. Route the
telephone line cord (or DSL lter) through the wall-mount bracket hole.
2. Align the holes on the wall-mount bracket with the standard wall plate and
slide the wall-mount bracket down until it locks securely.
3. Position the telephone base, as shown below. Insert the extended tabs
(marked B) of the wall-mount bracket into the slots on the back of the
telephone base. Push the telephone base down until it is securely in place.
4. Plug the power adapter into a power outlet not controlled by a wall switch.
Plug the other end of the power adapter into the telephone base. Bundle
the telephone line cord and power adapter cord neatly with twist ties.
Installation options
Your telephone base is ready for tabletop use. If you want to mount your
telephone on a wall, follow the steps mentioned below, to connect the
telephone base with a standard dual-stud telephone wall-mounting plate.
You may need a professional to install the mounting plate.
Tabletop to wall-mount installation
B
A
1
2
3
4
To Next Page
Loading...
Need help?
General
