Multiple handset use
75
Intercom
Using the telephone base:
1. Press MENU in idle mode to enter the main menu.
Press qCALLER ID or pDIRECTORY to scroll to Intercom,
then press SELECT.
f If you have one handset and no other registered
devices, the telephone base shows Calling
HANDSET X.
f If you have other registered device(s) or more than
one handset, the telephone base shows INTERCOM
TO:. Use the dialing keys to enter a specific handset
number (1-9 for handsets 1-9, TONE followed
by 0-2 for handsets 10-12, or # for a single headset/speakerphone, #
followed by 1 or 2 for headset/speakerphone 1 or 2, or TONE followed
by # for all devices), or press qCALLER ID or pDIRECTORY to scroll to the
desired handset and press SELECT. The telephone base shows Calling
HANDSET X or Calling all.
The destination handset(s) rings and shows Base is calling, BASE 0 is
calling or BASE 0 is calling all.
2. To answer the intercom call, press HOME, CELL 1, CELL 2 or any dialing key
(0-9, TONE ) on the telephone base. Both the base and the handset now
show Intercom.
3. To end the intercom call, one party presses END, OFF/CANCEL, or places
the handset back in the telephone base or charger; or one party presses
END on the telephone base. The other party hears four beeps. Both
devices display Intercom ended.
Notes:
f Before the intercom call is answered, you can cancel it by pressing OFF/CANCEL on the handset or END on the
telephone base.
f If the called party does not answer within 100 secon
ds, or if
the devic
e is in use
, on a call or out of range, the
initiating device shows No answer. Try again..
f To temporarily silence the intercom ringer, press OFF/CANCEL or MUTE/DELETE on the handset, or press
CANCEL or MUTE on the telephone base.
f You can only use one pair of devices at a time to make intercom calls.
f For cordless headsets and speakerphones, refer to the corresponding user’s manual on how to answer and end an
intercom call.
f If a total of two cordless headset(s) and/or speakerphone(s) are registered to the telephone base, they appear as
HEADSET 1 and HEADSET 2, respectively, in the intercom menu.
Smart call blk
Directory
Caller ID log
Intercom
p
q
SELECT
BACK
INTERCOM TO:
HANDSET 1
HANDSET 2
All
p
q
SELECT
BACK