191
Appendix
Troubleshooting
I’ve set my LCD language to Spanish or French and I don’t know how to
change it back to English.
f Press MENU on your handset or base in idle mode, then enter 364# on the
The handset registration is unsuccessful.
Follow the steps, as mentioned below, to register the handset again.
1. Make sure the handset is out of the telephone base or charger and shows
To register, see user manual
before you begin registration.
2. Place the handset you wish to register on the telephone base cradle. The
handset displays Registering... Please wait on the handset. It takes about
90 seconds to complete the registration process. The handset displays
HANDSET X Registered (X represents the registered handset number) and
the beeps when registration completes.
Refer to the Add and register handsets/headsets/speakerphones section on
pages 161-162 for details.
Common cure for electronic equipment:
If the telephone is not responding normally, try resetting the telephone. Do the
following in the order listed:
1. Disconnect the power to the telephone base.
2. Disconnect the handset battery, and spare battery, if applicable.
3. Wait a few minutes.
4. Connect power to the telephone base.
5. Completely remove the battery. Replace the battery and place the handset
into the telephone base.
6. Wait for the handset to reestablish its connection with the telephone base.
Allow up to one minute for this to take place.
To Next Page
Loading...
Need help?
General
