NOTE: Pay close attention during the execution of the next steps: the two Miniature Fuses
could fall down on the floor. This is due to the fact that it is not necessary to remove the
Focus 60 / Focus 61 from its working position.
4. By using a shaped tool (i.e. screwdriver), extract the
Fuses Holder as shown in the picture on the right:
5. After extracting the Fuses Holder, it is possible to
see the two Miniature Fuses (refer to the picture on
the right).
Remove the old Miniature Fuses and install the new
ones.
To Next Page
Loading...
