Focus 60 / Focus 61 User Guide Maintenance
9839 0211 01 Edition 1.1 103 (106)
6. After installing the new Miniature Fuses, push the
Fuses Holder into its housing as shown in the picture
on the right:
NOTE: Use ONLY the power cable provided with the Focus 60 / Focus 61 package. If you use
any other power cable, the protection provided by the equipment may be impaired.
7. Reconnect the power cable to the multifunctional power socket
8. Reconnect the power cable to the AC Power.
NOTE: Switch the Focus 60/ Focus 61 on, to verify that fuses replacement was done
correctly. Check, that the light of the On-Off switch is red and if the other LEDs (on the front
panel) illuminate correctly.
To Next Page
Loading...
